Hanging boards - installation instruction (step by step)

header Variant I - the board horizontal:

   (the bindings not required)

horizontal hanging

In the first variant the straps can be next to or between the bindings. There is no problem with hanging the board without bindings.

Installation instruction:

  • choose the place on the wall to hang your board,
  • on the wall mark two points, where the plugs with hooks are to be fixed,
  • make two holes with the drill bit Ø 8 mm,
  • put the plugs in to the holes and screw in hooks,

hooks installation

  • attach the single ends of straps to the hooks,
  • put the boards and attach the other ends of the straps so that the board hangs between them.

header Variant II - the board diagonally:

   (the bindings required)

diagonally hanging

In the second variant both straps should be adjusted on the left side (or on right side) the bindings. No way to hang the board without bindings.

Installation instruction:

  • choose the place on the wall to hang your board,
  • on the wall mark two points, where the plugs with hooks are to be fixed. Hanging board diagonally needs to choose one point lower, but maximum gradient should be not more than 45 degrees,
  • make two holes with the drill bit Ø 8 mm,
  • put the plugs in to the holes and screw in hooks,

hooks installation

  • attach the single ends of straps to the hooks,
  • put the boards and attach the other ends of the straps so that the board hangs between them.


Valid HTML 4.01 Transitional Valid CSS!

BACK BACK | TOP TOP